![]() ![]() No crypto isakmp client configuration browser-proxy browser-proxy-name Syntax Description To disable the browser-proxy parameters, use the no form of this command.Ĭrypto isakmp client configuration browser-proxy browser-proxy-name Use the crypto isakmp client configuration browser-proxy command in global configuration mode. To configure browser-proxy parameters for an Easy VPN remote device and to enter ISAKMP browser proxy configuration mode, The following example references IP address local pools to IKE on your router, with “ire” as the pool-name:Ĭrypto isakmp client configuration address-pool local ire Related CommandsĬonfigures a local pool of IP addresses to be used when a remote peer connects to a point-to-point interface.Ĭrypto isakmp client configuration browser-proxy On your feature set, platform, and platform hardware. Support in a specific 12.2SX release of this train depends This command is supported in the Cisco IOS Release 12.2SX train. This command was integrated into Cisco IOS Release 12.2(33)SRA. ![]() This command was integrated into Cisco IOS release 12.0(7)T. IP address local pools do not reference IKE. Specifies the name of a local address pool. No crypto isakmp client configuration address-pool local Syntax Description To restore the default value, use the no form of this command.Ĭrypto isakmp client configuration address-pool local pool-name To configure the IP address local pool to reference Internet Key Exchange (IKE) on your router, use the crypto isakmp client configuration address-pool localcommand in global configuration mode. Router (config)# crypto isakmp aggressive-mode disable crypto isakmp client configuration address-pool local The following example shows that all aggressive mode requests to and from a device are blocked: This command will prevent Easy Virtual Private Network (Easy VPN) clients from connecting if they are using preshared keysīecause Easy VPN clients (hardware and software) use aggressive mode. Unable to initiate or respond to Aggressive Mode while disabled If a request is made by or to the device for aggressive mode, the following syslog notification is sent: If you configure this command, all aggressive mode requests to the device and all aggressive mode requests made by the deviceĪre blocked, regardless of the ISAKMP authentication type (preshared keys or Rivest, Shamir, and Adelman signatures). This command was introduced on all Cisco IOS platforms that support IP Security (IPSec). In addition, if the device has been configured with the crypto isakmp peer address and the set aggressive-mode passwordor set aggressive-mode client-endpointcommands, the device will initiate aggressive mode if this command is not configured. If this command is not configured, Cisco IOS software will attempt to process all incoming ISAKMP aggressive mode securityĪssociation (SA) connections. This command has no arguments or keywords. No crypto isakmp aggressive-mode disable Syntax Description To disable the blocking, use the no form of this command. Use the crypto isakmp aggressive-mode disable command in global configuration mode. To block all Internet Security Association and Key Management Protocol (ISAKMP) aggressive mode requests to and from a device,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |